Experimental Heat Pumping and Accumulation Simulator Vocational Training Equipment Fridge Training Equipment

ZM6192 Experimental Heat Pumping and Accumulation Simulator Vocational Training Equipment Fridge Training Equipment

You should give an experience and train on temperature control, automatic pressure control device pressure, and automatic defrost.

You should give an experience and educate theoretically about the automatic control of the refrigeration system and the refrigerator components.

You must establish the temperature range measure to create the P-I Diagram, so that these experiments and training are available, such as equipment change cycles,Secondary heat exchange, through the heat accumulation tank.

You should check and adjust the flow of the heating medium (Water)

You must obtain the most accurate data through the high and low pressure switch.

The heat accumulation tank must be able to be visualized through transparent acrylic and the thermotherapy must circulate through the circulator.

It should be structured in order to accumulate heat, to be able to see the states and flow of the refrigerant, and to understand the principle of the components, so as to maximize the achievements of education.

It must be composed of accessories, in order to visualize the state, principle and flow of the refrigerant.

You must have the power control (ON / OFF), monitors and data stored in the computer of the electrical control panel, through software.

Must have fault insertion and simulation

User manual in Spanish with theory and practices for instructor and student

Size: 1800x1400x1000mm

Freezer main controller

– Adopted 32-bit high-performance ARM processor

– Built-in USB port for PC connection

– Up to 16 temperature modules can be interlocked

– Built-in RS-485 communication terminal for multipoint communication

– The RS-485 communication circuit must be designed as an insulation structure to improve noise immunity.

– 12-bit AD input for pressure and humidity sensor interlocked 16Ch

– Built-in 16-channel digital input for function control.

– 16 built-in LEDs to verify the output status inside the PCB

– Built-in 16 external LEDs to verify the output status

– Up to 16 relay output channels (8 basic channels, 8 optional channels)

– The relay for the output must have a rating of 10 A or higher.

– The SMPS and DCDC converter must be integrated and designed with an external signal and an insulation structure.

– Power source: AC86 ~ 264V, 50 / 60Hz free voltage

– Within the size of PCB 250X140

It should contain the components listed below as:

Compressor 1 / 2HP, Single Phase 220V, Control Box

Air-cooled condenser, single phase 220V

Evaporation pump and chamber with heat accumulation.

1 / 2HP Liquid Receiver

1 / 2HP accumulator

Manual or welding expansion valve.

Electronic valve for 3/8 ’operation with nut clamp, or welding.

3/8 ’’ Filter Dryer with nut clamp, or welding.

Pressure gauge: High pressure, Low pressure.

High pressure switch, low pressure.

Loading nozzles

Acrylic visor, with nut or welding pliers

Check valve (Welding)

4-way valve (Welding)

Refrigerator temperature module

– Built-in 4Digit FND with good visibility

– Up to 16 temperature modules can be interlocked

– Built-in RS-485 communication terminal for multipoint communication

– RTD type temperature sensor input

– Accuracy within ± 0.2 degrees

– Built-in 10A rating relay

– Built-in 4-bit rotary switch for address configuration

– Using a 10 A output relay

– Power source: DC24V

– Front PCB size within 70X50