AC Circuit Electrical Training Equipment Electrical Experiment Equipment

AC Circuit Electrical Training Equipment Electrical Experiment Equipment

SR6101E AC Circuit Electrical Training Equipment Electrical Experiment Equipment
1 Introduction
In this experiment, three waveforms of sine wave, square wave and triangle wave can be output, and three kinds of waveforms can be used for fine adjustment of frequency, amplitude, linearity and duty ratio. A variety of measuring instruments can be completed by providing three kinds of measuring instruments: AC10V, DC100uA and DC10V. Through the experiment, and master the principle and control mode, the corresponding knowledge and skills, suits, higher vocational colleges, secondary vocational schools and vocational school related professional teaching and skills training examination.
2.Technical requirement
Signal Source: 3 mode, Frequency range 1 – 10kHz. Sine, square and triangular. Variable output voltage level on all waveforms 0-10V peak- to-peak nominal, Moving coil meter 0-100 μA movement, scaled 0- 10V peak/mean switchable

  • Description
  • Inquiry

SR6101E AC Circuit Electrical Training Equipment Electrical Experiment Equipment
1 Introduction
In this experiment, three waveforms of sine wave, square wave and triangle wave can be output, and three kinds of waveforms can be used for fine adjustment of frequency, amplitude, linearity and duty ratio. A variety of measuring instruments can be completed by providing three kinds of measuring instruments: AC10V, DC100uA and DC10V. Through the experiment, and master the principle and control mode, the corresponding knowledge and skills, suits, higher vocational colleges, secondary vocational schools and vocational school related professional teaching and skills training examination.
2.Technical requirement
Signal Source: 3 mode, Frequency range 1 – 10kHz. Sine, square and triangular. Variable output voltage level on all waveforms 0-10V peak- to-peak nominal, Moving coil meter 0-100 μA movement, scaled 0- 10V peak/mean switchable
3 Operate instructions
1. Carefully check whether there is any safety hazard in the power supply line before power supply. (for example, the copper wire of the insulating layer breaks out and is not allowed to be used)
2. Insert the power cord plug into the AC22V power input socket and power the panel.
3. Turn on the power switch and the whole circuit is connected. Connect the oscilloscope to the signal output terminal, adjust the knob according to your needs, and find the appropriate waveform.

We will contact you within 1 working day, please pay attention to the email.